And you are now ready to start working with the ESP8266.Įts Jan 8 2013,rst cause:2, boot mode:(3,7) If your serial transmission rate is correct, try typing “AT”: it should echo the characters as you type them and should return an “OK”. Picocom -b 115200 /dev/ttyUSB0 -omap crcrlfĪnd you are ready to send your first commands! However, picocom can be easily configured to send a linefeed after each carriage return. Hence, you need press followed by Ctrl-J to send a command.
Please note that most recent ESP firmwares require Carriage-Return-and-New-Line (\n\r - ASCII 10 13) line endings. The ones to try first are 9600 (it depends on the version of the firmware running onboard). First, your board might talk at any of several baud rates. For that, a terminal emulator like picocom or the standard screen command will do the job. At this point, I wanted to start talking to the ESP.
I connected the module to my PC through the FTDI cable.
0 kommentar(er)
